Description
4 bedroom villa with swimming pool in the Amora area.
Two-storey house, with garage and salt water swimming pool.
Good outdoor space behind and also in front of the house.
Barbecue area.
Floor 0 - Living room, kitchen, bedroom and bathroom bath
1st floor - Two bedrooms and another suite with closet
The bedrooms all have built-in wardrobes.
Characteristics of the house:
• Ground floor with air box ventilated
• Flooring on the ground floor with a 16 centimeter layer of lecca in order to protect against moisture coming from the ground, in addition to ventilation
• Placement of asphalt screen on all exterior walls to isolate the land slope, from the foundation to at a height of 25 centimeters above the interior floor
• Hood system with 10 centimeters EPS • To increase thermal inertia, the exterior walls were plastered on both sides (interior and exterior)
• Facade walls made of 20 centimeter thermal block
• Galvanized metal profile under facade walls to prevent the rise of moisture from the ground by capillarity
• There are no air spaces in the facade walls to increase thermal inertia , in addition to existing, they would have to be ventilated, which would provide air circulation inside the walls, which would have to be controlled
• Facade walls lined from the inside, by directly attaching them to the plasterboard plaster with adhesive mass so that there is no air gap
• Construction Portfolio • Fans (mandatory) placed in the blind boxes to allow the renewal of interior air, to which a membrane is adapted that automatically opens or closes, depending on the air intake flow rate
• Marble stones with chest or sill with thermal cut chest or sill with thermal cut. They are discontinued under PVC frames in order to cut off any thermal transmission from the outside
• Flooring on the 1st floor with a 16cm layer of lecca (expanded clay), in order to increase the interior acoustic and thermal quality
• Covering slab – Layer of reinforced concrete and over this thermo-acoustic insulation (XPS) 10cm thick. On top of this, a layer of lecca (expanded clay), approximately 10/15cm thick, slopes towards the water and for thermal-acoustic insulation. Leveling screed for placing shale asphalt fabric
• Placing shale asphalt fabric in two crossed layers
• Insulation through painting using white anti-UV paint so that there is no absorption of solar rays
• The platband, in its upper part it has a lacquered aluminum roof, with an asphalt screen underneath for any unexpected correction
• Construction protected by the hood and the screen behind it. All skirting boards placed against the house have a silicone cord at the top joint
• Interior walls all made of 15mm plasterboard on both sides, based on a metal structure, with a layer of rock wool between them, varying between 40 and 60mm , increasing the thermal and acoustic quality of the home
• Ceilings made of plasterboard, supported by a metal structure, and on top of this a rock wool covering, increasing interior thermo-acoustic comfort • Existence of pre-installation of AC
• PVC frames with double glass
• Home automation – All control of the home automation system in the house can be carried out by the owners' personal cell phone:
a) Control and video surveillance
b) Alarm signal
c ) Turning the alarm on and off
d) Touch answering at the entrance door with remote viewing
e) Control with programming the opening and closing of blinds
f) Control with programming to turn on and off the interior lights and exterior
g) Opening and closing of automatic gates
Come Visit
"Your House Lives Here"
José Marques
1 / 8
2 / 8
3 / 8
8 / 8
